Colloidal Silver Zinc Blend
Using this site means you accept the Terms & Conditions 

These products and statements have not been evaluated by the United States Food and Drug Administration and are not approved to diagnose, treat, cure or prevent disease. The information provided on this site is for informational purposes only and is not intended as a substitute for advice from your physician or other health care professional. You should not use the information on this site for diagnosis or treatment of any health problem or to prescribe medication for a treatment. You should always consult with a healthcare professional before starting any diet or supplementation program. Product availability, pricing, and promotions are subject to change without notice.

Topics Discussed:   Understanding High PPM of Atomic Size Particles

GoldenGevity High PPM Products
Open weekdays 9 AM- 4 PM 619-752-6777
Understanding Parts Per Million of Atomic Particles 
Black Line 3
Black Line 4
Black Line 2
When considering the purchase of Colloidal Silver one must always keep in mind, that the sellers will promote their explanations as to why their products are best. In doing so, they may twist the truth to make their products appear to be safe.

One argument our opponents often use to confuse readers is by stating that a TDS Meter is not accurate and that the correct method of counting PPM is with an ICP Spectrometer. True, because chemicals that THEY use can interfere with the accurate PPM count.  

We do not have that problem. The irony of their argument is that they use a TDS Meter themselves on a daily basis to make sure they have the correct PPM reading. 

The ICP Spectrometer is practical for nanoparticle and Ionic Solutions, but it will destroy or change the solution when the test is applied. The ICP Spectrometer analysis is not suited to test the end products PPM Content for every bottle they make; they would have to use the TDS Meter because it will not spoil the solution.

Atomic Particles in distilled water is very difficult to test with average Instruments. 

The Atoms first have to be consolidated into larger nanoparticles that can then be calculated. The Plasma Arc ICP Spectrometer is employed for this method. It will convert the Atoms into nanoparticles, and at the same confirm what element is within the solution.

The only way it can work for Atomic Particle solutions is that it will burn the solutions contents and create large nanoparticles that can then be estimated. In the process, much of the solution is dissipated, along with the evaporation, some atomic particles will also disappear into the air along with the evaporated water molecules.  

Therefore, the ICP Spectrometer Test may give you a semi-accurate idea of how many Silver Saturated Water Molecule Clusters can be converted into nanoparticles.

The reason we say "may" is because the test is dependent on how the Plasma Arc that burns the solution and converts the Atomic Particles is applied. 

If the solution gets too hot, it may evaporate everything and render a very low nanoparticle count, or no count at all. If it is slowly heated, then it will render a higher PPM number. 

So, it is important to use a reputable testing facility that is not affiliated with the manufacturing company and is non-prejudiced in their conclusions. 

The typical TDS Meter that every manufacturer uses to test the PPM of their solutions can actually detect Atomic Particle Silver Saturated Water Molecules.

​When we say "3000 PPM" it means the TDS Meter has detected 3000 Silver Saturated Water Molecule Clusters. 

Nanoparticle PPM is limited, having a 20 PPM is like having 20 Nanoparticles per millions of parts of the chemical solution.



TheThe above Chart may raise more questions like:

1. "Then your product is a Low PPM Product?"

  Answer:  

No, a Plasma Arc ICP Spectrometer was used to convert the atomic particles into nanoparticles, that proves that even though you have a high ppm of atomic particles, the atomic particles when converted do not exceed the commonly accepted RDA (Recommended Daily Allowance) that apply to the nanoparticle or ionic colloids.  

​2. "Then why does your TDS Meter measure in nanoparticles"?

Answer:   

The TDS Meter measures Conductivity as well as PPM of Total Dissolved Solids; it will measure nanoparticles and even Water Molecule Clusters that have atomic or mineral elements that are attached to them. Atoms are much too small to be detected y themselves with a TDS Meter.

As mentioned above: 3000 PPM of our atomic particle colloidal silver would have about 3000 Water Molecule Clusters that have hundreds of thousands if not millions of silver atoms (in overall atomic particle content) attached to them. 
One Silver Saturated Water Molecule Cluster will be read as ONE PPM on the TDS Meter.

One Silver Saturated Water Molecule Cluster is comparable to about ONE 6 nm particle, with the exception that it contains tens of thousands if not hundreds of thousands of Atomic Particles of Silver (or whatever element is employed). 

Larger silver saturated water molecules may contains millions of atomic particles.

Each PPM of Atomic Particle Colloidal Silver will have a "CLUSTER BOMB EFFECT" on viruses, bacteria, and even parasites when the water molecules dissolve and release the contained silver atoms into the blood stream.

3000 to 18,000 PPM, means we  have 3000 to 18000 PPM of Silver Saturated Water Molecules Clusters.

​We have found many companies that claim to have a high PPM of 500 and under truly have 5 to 20 PPM, with this simple TDS meter test.

A TDS Meter can be purchased on the internet for under $40.00.
High PPM Colloidal Silver Certificate of Analysis
TDS Meter Test of Colloidal Silver 12000 PPM
Competing individuals selling inferior Low PPM products often accused us of just having water, consequently, we contracted the world's largest environmental testing company to convert our atomic particles into nanoparticles and verify that the elements that we use are in the solution as well, via the ICP Plasma ARC Spectrometer Test.  

The following image is a cutout portion of our Certificate of Analysis. (Terms and Conditions do not allow us to display the entire CA since they do not endorse or want to appear as supporting any products).
This simple test called the Tyndall Effect done with a laser proves that our Colloidal Silver Water Molecules are Saturated with hundreds of thousands (if not millions) of Atoms.
Black Line 2
Black Line 1
Black Line 2
Black Line 2
Colloidal Silver
You've tried the rest, now try the BEST!